噴霧干燥在實際作用時應采用兩臺霧化器輪換使用.一般霧化器在使用一段時間后應拆下零件清洗干凈.如有擦傷可以用細料紗布打光.有嚴重擦傷的應該更換零件.如果連續使用時間較長時,可以配水箱冷卻已適當延長使用壽命.六在拆裝霧化盤等零件時應該**注意,不要把主軸碰彎,固定霧化盤的左旋諾姆一定要擰緊,防止松動脫落.七每月需要更新油一次,更換時拆下霧化盤和外罩殼,寧下幾座下端的放油螺絲,待舊油放干凈后再用生料帶包上放油螺絲重新擰上住上新油,注意不要超過或低于油位線。